Common Name (Used on Label): PC6 Waterborne Urethane Metallic
Chemical Name: Paint
Chemical Family: Urethane dispersion
CAS No: None
|Hazardous Components||CAS No.||Pressure||TWA||STEL||PEL||CEILING||PEAK|
Specific Water Reducible Enamel colors contain one or more of the following. See Section 12-Other Information.
|Carbon Black||1333-86-4||none||3.5mg/m3 NE||3.5mg/m3||NE||NE|
|Aluminum Silicate||1332-58-7||none||10mg/m3 NE||15mg/m3||NE||NE|
|Titanium dioxide||13463-67-7||none||10mg/m3 NE||10mg/m3||NE||NE|
|Amorphous Silica||7631-86-9||none||10mg/m3 NE||6mg/m3||NE||NE|
|Amorphous Fumed Silica||112945-52-5||none||10mg/m3 NE||20mg/m3||NE||NE|
|Aluminum Flake||7429-90-5||none||10mg/m3 NE||15mg/m3||NE||NE|
Boiling Point: 206 F – 343 F
Percent Volatile by Volume: 60
Solubility in Water: 65%
Specific Gravity: 1.056-1.2185
Vapor Density (Air =1): Heavier
Reactivity in Water: None
Vapor Pressure (mm Hg): NE
Evaporation Rate (Ether=1):Slower
Appearance: Pigmented liquid
VOC: 26 g/l as packaged, 39 g/l less water as applied
Flammability Classification: OSHA: Combustible DOT: Not Regulated
HMIS: Health 2; Flammability 1; Reactivity 1
Flash Point: 144˚ F 62˚ C Method Used: TCC
Extinguisher Media: NFPA Class B (CO2, Dry Chemical, Foam)
Flammable Limits in Air % by volume: LEL Lower: NE UEL Upper: NE
Auto-Ignition Temperature: NE
Special Fire Fighting Procedures: Water spray may be ineffective on fire but can protect fire fighters and cool containers to prevent pressure buildup. Use fog nozzles if water is used. Full protective equipment, including self-contained breathing apparatus, is recommended.
Unusual Fire and Explosion Hazards: When heated above the flash point, emits flammable vapors which, when mixed with air, can burn or be explosive. Fine mists or sprays may be flammable at temperatures below the flash point. Closed containers may explode if exposed to extreme heat.
Conditions to Avoid: Keep away from heat, sparks, electrical equipment and open flame.
Incompatibility (materials to avoid): Acids, alkalis, strong oxidizing agents.
Hazardous Decomposition Products: Carbon dioxide, carbon monoxide.
Hazardous Polymerization: Will not occur
Skin: May cause irritation. Other effects of skin contact include defatting leading to dermatitis and dehydration.
Eye: May cause eye irritation with moderate to severe redness, swelling and some corneal injury lasting several days to a week.
Inhalation: May cause respiratory tract irritation and central nervous system effects including headache, nausea, coughing, sore throat, runny nose. Ingestion: Harmful if swallowed.
Notice: Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal. Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage.
Repeated overexposure to this product may cause central nervous system damage, lung damage, liver and kidney damage.
Exposure to experimental animals via inhalation, skin absorption, or ingestion produces a toxic effect on red blood cells. This was often associated with secondary effects such as spleen and liver enlargement and nephropathy. Studies show that hemolysis and secondary effects are not relevant to humans.
Based on an IARC conclusion that there is sufficient” evidence in experimental animals for the carcinogenicity of carbon black” andinadequate evidence of carcinogenicity in humans, IARC’s overall evaluation is that “carbon black is possibly carcinogenic to humans” (Group 2B).
Carbon black has not been listed as a carcinogen by the National Toxicology Program (NTP), or the Occupational Safety and Health Administration (OSHA). The National Institute of Occupational Safety & Health (NIOSH) criteria document on carbon black recommends that only carbon blacks with PAH (polynuclear aromatic hydrocarbons) levels greater than 0.1% be considered suspect carcinogens. The carbon black pigment used in this product contains less than 0.1% PAH.
Inhalation: Remove to fresh air. Give artificial respiration if necessary. Consult a physician.
Eye Contact: Flush with water for at least 15 minutes. Consult a physician.
Skin Contact: Wash with soap and water. If irritation persists, consult a physician.
Ingestion: DO NOT induce vomiting. Call a physician immediately. Have the names of ingredients available.
Observe label precautions. Keep away form heat, sparks and flame. Close container after each use.
Wash thoroughly after handling and before eating or smoking.
Do not store above 120 degrees F. Do not flame cut, saw, braze or weld containers. Empty containers may contain hazardous product residues. Launder contaminated clothing before reuse.
Steps to be taken in case material is released or spilled: Remove all sources of ignition. Isolate from oxidizers. Ventilate area. Remove with inert materials and non-sparking tools.
Waste disposal methods: Dispose in accordance with all Federal, State and Local regulations.
Do not breathe vapors or mists. Wear an appropriate, properly fitted respirator (NIOSH/MSHA approved) during application and handling unless air monitoring demonstrates vapor/mist levels below applicable limits. Follow respirator manufacturer’s recommendations for selection and use. Ventilation: Provide sufficient ventilation to keep vapor concentration below the given TLV and/or PEL.
Protective clothing: Solvent resistant gloves are required for prolonged or repeated contact. Refer to safety equipment supplier for effective glove recommendations.
Use safety goggles or safety glasses with splash guards or side shields to protect against splash of liquids.
Other protective equipment such as eye bath and shower should be available. Use chemical resistant apron, boots or other clothing if needed to avoid repeated or frequent contact. Liquid may penetrate shoes and leather causing delayed irritation.
OSHA: This product is considered hazardous under the Federal OSHA Hazard Communication Standard.
SARA Title III Section 302 Extremely Hazardous Substances: None
SARA Title III Section 311/312 Hazard Categories: Immediate health, delayed health, fire hazard.
Section 313 Supplier Notification: The chemicals listed below with percentages are subject to the reporting requirements of Section 313 of the Emergency Planning and Right-To-Know Act of
|1986 and of 40 CFR 372:|
|CAS Number||Chemical Name||% by Weight|
Hazardous Air Pollutants: Triethylamine CAS 7087-68-5
TSCA status: All ingredients are TSCA registered.
CEPA status: All ingredients are listed on the DSL or NDSL.
Proposition 65 Warning: This product contains a chemical known to the State of California to cause cancer: none
While Precision Coatings believes that the data contained herein are accurate and derived from qualified sources, the data are not to be taken as a warranty or representation for which Precision Coatings assumes legal responsibility. They are offered solely for your consideration, investigation, and verification. Any use of these data and information must be determined by the user to be in accordance with applicable federal, state and local laws and regulations.